I am about to spray paint my kitchen cabinets that I am building. I did a test piece, which turned out okay. But from what I understand I should be able to get an even smoother finish, since I am using a spray gun and a nice paint like Sherwin Williams EUTE. Do y'all have any advice for how I can improve the finish?

Details of my process:

• Substrate = birch plywood, sanded to 220 grit

• HVLP sprayer = Super Finish Max HVLP Sprayer using a 2.0 mm tip

• Primed with one coat of SW Wall & Wood Primer

• Sanded after priming w/ 600 grit sandpaper (might be too high? - it's what I had on hand)

• Sprayed first coat of Sherwin Williams Emerald Urethane Trim Enamel paint in semi-gloss

• Next day I lightly sanded and applied a second coat of paint

• Each coat dried with the test piece laying down, to give it the best chance of leveling out.

• 50% overlap when spraying

I suspect I might have applied it too thinly. I read a post of this sub about someone applying EUTE too thickly, which resulted in the paint failing to fully cure, even months later. One of the comments said that darker colors take longer to cure, as well. For those reasons I was a bit afraid of putting it on too thick, and I used a smaller 2.0 mm tip (I have 1.4, 2.0, and 4.0 mm tips). Does it look like I sprayed too thinly, or is there some other cause?

Any recommendations on how to get a smoother finish are greatly appreciated.

Planning to spray newly built cabinet doors with SW emerald urethane. I sprayed a vanity previously with BM Advance and it didn’t come out great. Wondering if it had something to do with spray technique or setup.

Sprayed with a FFLP 210 out of a Grace X7. The knob was at the lowest setting and it was putting out what I would consider a good fan. Not the best sprayer but it’s what I have.

Problem is the finish is not great, it’s okay, but not glassy smooth. Wondering what can be done differently on kitchen cabinets to get a higher quality finish.

Second question is about spraying in a garage with a radiant heater. I know the heater heats objects and not the air so will I run into issues letting the doors dry in there?