"FLAT" to "RST." Step 3: Continue holding the FLAT button for an additional 30-60 seconds as the bed moves forward and backward. If the base is in a raised position, it will lower during this process.

Please ensure that remote(s) have fresh batteries. ... Unplug the base(s) for approximately 60 seconds. Plug the base(s) back ... Press and hold the FLAT button. The LCD window will flash the word Flat. After 15 seconds, the LCD window changes from flashing FLAT to RST.

Step 1: Ensure the base is disconnected from the power source. Please ensure your remote has fresh batteries.

TEMPUR-Ergo™ Smart Control Operating Instructions............................................ 27 · ADVANCED REMOTE CONTROL PROGRAMMING............................................................. 28 · SPECIAL FUNCTIONS...................................................................................................... 30 · Reset...

August 11, 2025 - Continue holding the FLAT button for an additional 30-60 seconds as the bed moves forward and backward. If the base(s) were in a raised position, it will lower during this process.

Backup Box will go out. Release the PAIR button. The remote is now

August 3, 2025 - Holding the flat key for about 15 seconds will begin the reset process. Watch for changes on the LCD display, then release the key. How to unlock my Tempurpedic remote?

If the Tempurpedic adjustable base won’t move but the blue light is on, first ensure the remote’s batteries are fresh and properly installed. Unplug the base for 30 seconds to reset the control box. Check all cable connections between the ...

Test the remote control batteries and reset the system by unplugging it for 30 seconds. Mechanical obstructions or worn actuators can cause failure; lubricate moving parts and ensure no debris blocks movement.

FOR A NON-RESPONSIVE EASE, ERGO, OR ERGO EXTEND ADJUSTABLE BASE · START HERE: Initial Troubleshooting Checklist for a Non-Responsive Base:  Ensure your base is plugged in to a power outlet ·  Change the batteries in your remote control ·  Verify the Child Lock feature is disabled (see steps below) Steps to deactivate the Child Lock feature on your ·

Unplug the base for 60 seconds to reset the electronic components. Plug the bed base into a different electrical outlet, or test the current outlet with another working appliance (a grounded, electrical surge protector is recommended).

Wireless Remote Control Features.......................................................................... 17 · Operating Instructions............................................................................................. 18 ... System Reset...........................................................................................................

A reset is required in the following cases: ... Press and hold the FLAT button. After 15 seconds, the LCD changes from FLAT to RST. Continue holding the FLAT button for 30-60 seconds as the bed moves forward and backward.

This is easily restored. First, fully charge the remote by plugging it into the provided USB charger. Once charged or the remote wakes up, it should automatically connect to the bed it was last paired with.

After resetting the remote, test all the remote functions to see if it is working properly. If the issue persists, you may need to contact Tempur-Pedic customer service for further assistance. They can be reached at 1-800-821-6621 or you can visit their support page at www.tempurpedic.com/support.